Ranked in the top 1% of printers in North America, Modern Litho operates five production facilities in Missouri. Modern Litho’s decision is a further highlight in the successful long-term partnership between Kodak and the U.S. This marks yet another step in Kodak’s development of comprehensive AI based software solutions that help printers become more automated, efficient and profitable. Kodak is excited to announce the first implementation of the revolutionary KODAK PRINERGY On Demand Business Solutions at Modern Litho. Modern Litho has become the first worldwide site of Kodak's PRINERGY on-demand business solution. Today on Printing Impressions newsletter.Top 100 Print Buyers Forecasted for 2022.The real answer to that is our GM thinks it would be a great 'feather in our cap' never mind the pain and anguish it causes the production people. Which is why the question is can I extract the data from the calibration curve from Harmony to use as my current curve. Production manager wants to run the first iteration of the certification process exactly how we run our jobs and adjust from there. Test sheets done when Prinergy install happened. We have a PM done every 6 months and the exposure is tested and adjusted if needed.Īs far as the press and the printing is concerned you have been in the business long enough to know if there were problems prepress would be the first to hear about it When our Prinergy system was installed in 2008 these curves were created to make sure any tonal value in the file was accurately reproduced on the plate. I do understand the differences in the curve names. Have you run any press tests to make sure that there are no inherent press issues? You do need to make sure that your press is printing reliably and consistently otherwise your curves (G7 or otherwise) will cause problems.

You do need to make sure that your platesetter images consistently. There is a longish explanation as to why this is so here: The Print Guide: To linearize your CtP plates or not? Unless you are in an unusual situation there is no need to linearize your plates before creating curves (G7 or otherwise). Target and Current are presswork curves - not plate curves.Ĭalibration curves is the curve that will be applied to the plate. In short: Target curve is what you want, Current curve is what you're getting, and Calibration curve is what Harmony will create. A target curve represents the tonal or dot gain characteristic of the printing that you want to match.Ī current curve represents the tonal value or dot gain characteristic of your current printing.Ī derived calibration curve is what Harmony creates from your desired printing tonal or dot gain target and current tonal value or dot gain characteristic of your printing.

Prinergy software